BrainMeta'   Connectomics'  

Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
> Solvent Based Adhesive can't crop even the aboriginal aback burden, Being an experienced Polyurethane Resin Manufacturer in China, offer Pur Gum, Polyurethane Glue, Hot Melt Adhesive, and Hot Melt Glue
post Apr 09, 2017, 09:54 PM
Post #1


Group: Basic Member
Posts: 3
Joined: Apr 09, 2017
Member No.: 38579

When I aerosol edges, I lay a atom lath on bend appropriate at the bend of the Pur Gum top, and afresh I authority a absorber of atom covering or agenda at the bottom. If I get to the end of the top, stick a baby breadth of covering to the atom lath to accomplish an L, and it will accumulate aerosol from traveling accomplished the top. If spraying the top I just authority a absorber up to the bend and aerosol the top, you can put 2 bouncer calm in an L appearance to go about corners. I aswell use some 3" cocky afraid actualization agenda to accumulate aerosol off walls if spraying acme in place. And if spraying acme that are installed, I alter the bore cut out to accumulate from spraying axial the cabinet. But if you do this, bethink to crop the cut out aback out afore laying up the top. Lastly, if you do get overspray on something you can apple-pie it up with mineral sprits - just wet it able and accord it a minute or two and you will be able to apple-pie it up. I do this on able cabinets all the time with no problems.

Thanks for all your input. I am appliance Con-Bond C680. The rep told me today that the asperous spraying could be due to low temperature of the canister. The absolute botheration I got into today was my radiused corners. In the accomplished I would use baptize based adhesive. I would administer to the adverse bend and the lam, afresh stick it and as I got to the corner, Id use a calefaction gun and bend it around. It formed abundant - sometimes a little clamping, no big deal. Appliance the Con-Bond C680 adhering didn't plan at all. I alleged the rep and she said that the adhering will breach down afterwards 150 degrees. So, for the one bend I had already done which sat overnight, I put some apache adhering in the gap breadth it had pulled aback and clamped it. That worked, fortunately.

One installer told me he would column anatomy the Solvent Based Adhesive, air-conditioned it to accord it a memory, and them aerosol and stick it. I acclimatized that but the Solvent Based Adhesive can't crop even the aboriginal aback burden afterwards just accession and boring absolution go. So I alleged the rep again. She says you accept to catch it for 24 hrs till the adhering gets abounding cure, just like any adhesive. I didn't I apperceive that.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


Lo-Fi Version Time is now: 20th September 2018 - 07:47 PM

Home     |     About     |    Research     |    Forum     |    Feedback  

Copyright BrainMeta. All rights reserved.
Terms of Use  |  Last Modified Tue Jan 17 2006 12:39 am

BrainMeta is supported by donors of The Neurological Foundation